Confidence .

Renault CAN CLIP   PCB  Modification of the linear stabilizer 3  v The stabilizer produces  exactly 3  v  , and the USB controller on the PDIUSBD12 – on the datasheet should feed  3.3 volts  , Stabilizer 3  v Finalization On the reverse side under N07A, the bottom cut of the divider 271 = 270 Ohm is soldered to it with a “sandwich” in parallel with the resistor   SMD    222 = 2.2 kΩ   or evaporate the resistor 271 and solder the resistor 241 = 240 Ohm  The output of the stabilizer will be the required 3.3V. Renault can clip Stress Maps src:  http://www.xingobd2.com/free-shipping-deals-best-quality-can-clip-v175-for-renault-diagnostic-interface-with-full-chip-an2135sc-an2136sc-multi-languages.html For more details information, welcome to Add my Whatsapp (+86 18124509953 ), Your Private Secretary in Car Repair Area! 16 Hours Online at your Service! Xingobd2 ...

This is how to solve an issue of your  Renault CAN CLIP interface  with an error message “Problem in multiplex network” Almost ALL pcb Renault Can Clip has the bug as a wrong resistors (2 pc) in Low CAN.(Message – “Problem in multiplex network” will be shown) It’s a fairly common problem. The reason to the ugliness is banal – sealed resistors of smaller denomination. Instead of 26.1 kilohms (marking 2612), sealed with 2.61 kOhm (marking 2611). There is a file that point you what resistors must be replaced. Notice it when chose your Clip. It’s in Russian, but a picture explains all. The solution, I think, does not need to be explained. This is the best Renault CAN CLIP pcb with AN2135SC Source:  http://www.xingobd2.com/free-shipping-deals-best-quality-can-clip-v175-for-renault-diagnostic-interface-with-full-chip-an2135sc-an2136sc-multi-languages.html Consists of two boards – CAN and ISO (there are no single-board). On a working device, all four LEDs...